4ms Row Power 30

ROW POWER is a clean, regulated, and protected power solution for eurorack systems. 
ROW POWER 30 provides 30W of power, suited for any typical eurorack row (+12@1.5A/-12@.75A/5@.5A)

Simply plug a laptop style power supply into either of the barrel plugs on the 4HP panel. Connect your modules via flying-bus cables, or connect the ROW POWER to a Distro Board.

Daisy-chain multiple ROW POWERS to use a single power brick for multiple rows. Each row will be independently regulated and protected for ultra-low cross-talk between rows. Rows can also be hot-swapped (plugged/unplugged without powering the whole system down).

Features

• Two power jacks for daisy-chaining multiple ROW POWERS: a common laptop-style power brick could power 3-5 rows (typical)
• On/off switch cuts power without interrupting the daisy-chain
• ROW POWER 30 provides more than enough power for a 84HP or 104HP row of modules.
• Ultra-clean: Each rail is separately regulated with high-grade components
• Runs cool: ROW POWER is efficient so it won't heat up your system. Electronics like to chill!
• Skiff-friendly: only 27mm (1.1") with power connectors installed.
• CV/Gate headers for expansion
• Blade tabs for power entry, to be used in custom installations (e.g. if the 4HP panel is not used)
• Available in matte black, or white panel (limited time)

Specs:

• ROW POWER 30: +12V @ 1.5A, -12V @ 0.75A, +5V @ 0.5A
• Powered by laptop-style DC power supply: 2.1mm barrel, positive center, 15V-20V.
• A 90W power brick typically powers about 416HP (4 rows of 104HP).
• Noise performance figures to be released