Flight 6U

Enclave Flight 6U Features:

 

• 104hp x 2

•  2 5/8 Inches / 67mm Depth

• Horizontal and Vertical Use

• Case can close while patched

• Solid Dovetail Construction – no screws to pull out

• Military Grade two part polyurethane elastomer coating inside and out; Fabric Free (No Tolex to Snag or tear)

• Chevron Black Polymer Corners

• Back Rubber Feet

• Meets all Airplane carry on requirements; only 11 lbs without modules. Click here for list of Airline Carry on Restrictions.

• Vector Rails with Sliding Nuts. Rails have no slots for losing nuts. Rails are easily removable for adding or removing nuts; 20 M2.5 nuts per rail and 80 screws included

• Carrying handle

• Built In Eye pads for carrying strap

• 12 lbs

• Comes with Power Brick

 

Make Noise Powered Bus Board for Enclave Flight 6u:

 

• Power from +15V to +18V DC Wall-Wart, anywhere in the world

• Outputs: 1.4A +12V regulated, 1A -12 regulated, 250mA +5V regulated

• 20 euro power connectors (2 x 8 male .1" headers)

• Spade connectors for DC IN/ OUT/ GND (for chaining of DC power to multiple boards)

•  Spade connectors for +/-12V, System GND, +5V, and the CV/ Gate bus lines (for expansion)

• No heat to dissipate

• Low Noise, high stability

• Conservative Current rating

• Automatic ramp down to shut-off when current draw exceeds 2.2A

• Delayed power up to avoid false blowing of fuses (when powering up several Metasonix modules for example)

• Super-Efficient, averaging 90% efficiency. Much greener then typical linear supplies

• Unique design allow for powering two rows without the need for the passive bus board and additional wiring

• Lightweight and low profile (less than 18mm height)

 

We strongly suggest you anticipate your power requirements at www.modulargrid.net . You will quickly see that the Enclave power board is more than adequate for almost all configurations that will fit in a 104hp 6u case.